Material Handling Electrical power UNIT two
General Description
This energy unit options power up gravity down circuit. Activate the start out solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve using the lowering speed controlled from the stress compensated movement control valve. Merchandise of this series is often broadly utilized in the field of logistic gadgets for instance fork lift, mini lift table, and so forth.
Distinctive Notes
1. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned in advance of mounting the electrical power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which must also be clean and free of charge of impurities, N46 hydraulic oil is advised .
four. Oil altering is required following the original 100 operation hours,afterwards as soon as each and every 3000 hours.
5. The electrical power unit should be mounted horizontally.

Materials Dealing with Power UNIT 1
Basic Description
This power unit is created to the fork lift field, consisting of extremely effective gear pump, DC motor, manual raise and reduced valve, tank, ect. The up and down motion are managed from the lever of the manual release valve, which is equipped with an electrical switch to activate the motor. The lowing speed is controlled from the strain compensated movement control valve.
Specific Notes
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic elements concerned before set up of the electrical power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which should really also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil changing is required just after the first a hundred operation hrs, afterwards after just about every 3000 hours.
5. The energy unit shown is made to be mounted horizontally.