Energy UNITS FOR LIFT TABLE one
Basic Description
This energy unit is intended exclusively for your tiny lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit is extensively employed during the business of logistic devices for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed from the solenoid valve with all the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is designed exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as pace managed from the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is minimize, the decreasing movement is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This power unit is designed solely for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as velocity managed by a stress compensated movement handle valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This electrical power unit is built solely for that big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed through the adjustable needle valve. When the lift rises to a high positoin, but the electrical power provide is reduce, the reducing motion is controlled from the guide override function.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all the hydraulic parts concerned prior to set up of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. Oil altering is required just after the original one hundred operation hours,afterwards once every 3000 hrs.
five. The energy unit shown is built to be mounted vertically.